Part 1 Basic Functions 1-47
3. 2. 6 User Mode 5: Cold Sleep Setting Mode
Keep this mode always “oFF”. (Do not change this setting.)
It is possible to select whether the Cold Sleep function works or not on the User Interface (UI).
The purpose of Cold Sleep Mode is to reduce the power consumption by shutting off to
supply the power to the heater unit.
It can save more power than Warm Sleep Mode.
The temperature of the heater unit is about 150 degrees Centigrade when the KIP 7000
is ready. But if no print job or copy job is sent for a long time, it is best for saving the power to
stop supplying the power to the heater unit completely.
The Cold Sleep Mode will be cancelled automatically if only you send a print job or a copy
job from the outer device.
However, please understand it takes a little long time to recover from the Cold Sleep Mode
because it is necessary to raise the temperature again up to about 150 degrees Centigrade.
(Print does not start until the KIP 7000 gets ready.)
Reference
To Next Page
Loading...
