Part 1 Basic Functions 1-17
Pre-printed
Extremely slippery
Extremel
stick
Extremely thin and soft
OHP Film
1. 8. 3 Maintaining the Media
Keep the paper in the custody taking care of the following matters.
1. Do not expose the paper to the direct sunlight.
2. Keep the paper away from high humidity. (It must be less than 70%)
3. Put the paper on a flat place, do not damage the media.
4. If you will keep paper which you has already been unpacked, put it into the plastic bag to
avoid humidity in the media.
CAUTION
Do not use the paper with staple, or do not use such conductive paper as aluminium foil and
carbon paper.
The above may result in a danger of fire.
NOTE
(1) Print image may become light if printed on a rough surface of the paper.
(2) Print image may become defective if the print paper has an excess curl.
(3) It will cause paper mis-feed, poor print image or creasing if you use a paper that does
not satisfy the specifications.
(4) Do not use a paper of which surface is very special, such as thermal paper, art paper,
aluminium foil, carbon paper and conductive paper.
(5) Vellum exposed to air over a long period tends to cause a poor printing.
We recommend you that you remove one round on the surface of the vellum from the
beginning by the Initial Cut Key on the User Interface (UI).
(6) Remove fully any adhesive from the roll that may remain due to tape placed by the media
supplier.
To Next Page
Loading...
