Part 1 Basic Functions 1-38
“Dehumidify Heater Switch” is located on the left-rear side of the machine.
Press “H” to turn on the Dehumidify Heater.
NOTE
(1) There are several dehumidifying settings which can be set by the service personnel.
When these setting determine, the dehumidifier functions.
With any setting, the printer must be plugged in and the switch noted above must be
in the “ON” position.
Call your service personnel if you would like to change the switch setting.
Note that the user can not change the setting.
(2) To achieve the best image quality, we recommend that you use media that is unpacked
from the manufacture right before installing it into the printer.
If media is unpacked long before installation, poor image quality may occur.
Dehumidify Heater Switch
To Next Page
Loading...
