KIP 7000 - Page 49

Part 1 Basic Functions 1-43
MENU TEST
TONER REMAIN IMAGE DENSITY
job
ENTER
1) Select User Mode 1 “U1.” by pressing [ ] or [ ] key.
The setting value consists of 2 digits.
The left value is not used.
The right one is applied to the print from controller.
The following list shows the selectable setting value and their contents.
Setting Value Contents
0 Dot Enhancement Level 0 : None With
the Smoothing Function
1 Dot Enhancement Level 1 : Weak
2 Dot Enhancement Level 2 : Medium
3 Dot Enhancement Level 3 : Strong
4 Dot Enhancement Level 0 : None Without
the Smoothing Function
5 Dot Enhancement Level 1 : Weak
6 Dot Enhancement Level 2 : Medium
7 Dot Enhancement Level 3 : Strong
2) Press [Enter] key to change the Image Enhancement setting for the print from controller.
Image Enhancement setting
for the print from controller
MENU TEST
TONER REMAIN IMAGE DENSITY
job
ENTER
Applied to the prints
from controller
Press this key to change
of settin
g
for the
p
rint