30
INSTALLATION
TROUBLESHOOTING
Problem Rechargeable battery wand needs recharging.
Solution
There are two methods for charging the rechargeable battery wand — the dual charging station or the single
charger.
CAUTION: Rechargeable battery wand can only be charged with
Kirsch® provided charging options — alternative charging devices may result in permanent damage.
Removing the Rechargeable Battery Wand from the Mount
■
To safely remove the rechargeable battery wand from your shade, grasp the end of the battery wand that is
furthest away from the power socket.
CAUTION: Grasp the wand firmly prior to removal.
■
Using the indentation on the end of the battery wand, use your index finger to pull the battery out of the
mount.
NOTE: The mount should remain installed and plugged into the shade cable during this process. You will
simply remove the wand from the mount.
Problem Rechargeable battery wand needs recharging (continued).
Solution
Recharging Via the Dual Charging Station
■
Plug the dual charging station into a standard AC outlet.
■
Insert the nose of the rechargeable battery wand into the dual charging station slot.
■
Battery snaps firmly into place. A red indicator light confirms the battery wand is
properly inserted and is charging.
■
Once the battery has been fully recharged, the light indicator turns green. Charging may
take up to three hours, depending on your battery level.
■
Remove the battery wand from the charger.
Recharging Via the Single Charger
Remove the rechargeable battery wand from the mount, or insert the single
charger cable without removing from the shade.
■
Attach the plug adapter to the charger.
■
Plug the charger into a standard AC outlet.
■
Plug the charging cable into the charging outlet on the rechargeable battery
wand. The charging outlet is near the nose of the wand.
(Continued on next page)
To Next Page
Loading...
