KitchenAid KFGS306VSS - Page 19

2-9
Adjust Flame Height
The surface burner “low” ame should be a
steady blue ame approximately 1/4" (0.64
cm) high.
A. Low ame
B. High ame
A
B
If the “low” ame needs to be adjusted:
Theamecanbeadjustedusingtheadjustment
screws underneath the control knob.
A. Single valve
B. Dual valve
A
A
A
A
B
Adjustment for Single Valve:
1. SettheburnerametoLO.
2. Remove the control knob.
3. Hold knob stem with a pair of pliers. Use
a3/32"(#0[2mm])atbladescrewdriver
to turn the screw located within the shaft
ofthecontrolknobstemuntiltheameis
the proper size.
Turn adjustment screw “C” to the right to reduce
ameheight,turnadjustmentscrewtotheleft
toincreaseameheight.
A.  " (#0 [2.0 mm]) at blade screwdriver
(screwdriver shaft must be a minimum of
1

" (28.0 mm) long)
B. Control knob stem opening
C. Adjustment screw location
B
C
A
4. Replace the control knob.
5. Testtheamebyturningthecontrolfrom
LOtoHI,checkingtheameateachset-
ting
Adjustment for Dual Valve:
1. SettheinnercrownametoLO.
A. Inner crown
B. Outer crown
A
B