KITO ER2 - Combining with the Motorized Trolley

42
Assembling (continued)
■
Combining with the Motorized Trolley
●
Replacing the Top Hook of Body size ER2-B/C/D/E
1) Remove the Shaft Retainer Clip using
plier.
6) Mount the Shaft Retainer with Socket
Bolt.
5) Insert two Connection Shafts into the
hole of the Body size.
4) Remove the Top Hook and replace it
with the Suspender T.
3) Remove two Connection Shafts.
2) Remove the Socket Bolt from the Shaft
Retainer, and remove the Shaft Retainer.
●
Replacing the Top Hook of Body size ER2-F
1) Remove four Socket Bolts and remove
the Controller Cover.
2) Remove pan head screws of the Connection
Shaft and the Fixing Shaft (two screws
each), and remove the Shaft Retainer.
3) Pinch the respective upper ends of the
Connection Shaft and the Fixing Shaft
and pull out them.
4) Remove the Top Hook and replace it
with the Suspender T.
5) Insert the Connection Shaft and Fixing
Shaft into the mounting hole.
6) Fix the Shaft Retainer of the Connection
Shaft and the Fixing Shaft with pan head
screws (two screws each).
7) Mount the Controller Cover with four
pan head screws.
Connection
Shaft
Shaft
Retainer
Shaft Retainer
Clip
Suspender T
Suspender T
Connection
Shaft
Bracing Shaft
Controller Cover
Socket Bolt
O ring
O ring
Shaft Retainer
Shaft Retainer
Pan Head Screw
Pan Head
Screw
Panel
Top Hook
Socket
Bolt
Top Hook
For Double Chain Type
For Double Chain Type
CAUTION
• When using ER2 series electric chain hoist combined with our old type product, specification needs to
be changed. Contact your nearest dealer or KITO.
■
Parts replacement of the electric chain hoist
The Suspender is attached to the electric chain hoist at shipping.
Refer to the following figure to remove the Top Hook and replace the Suspender with the Suspender T.
Prohibited
Chapter 1 Handling the Product
1
AssemblingCombining with the motorized trolley