klover DIVA - The Menu - Chrono-Thermostat

7
2. THE MENU - CHRONO-THERMOSTAT
The Menu is accessed by pressing key 3 (Set) twice.
This is divided into different levels (called UT...) to access the board's programming and settings.
The technical programming access menu entry (UT04) (parameters reserved to Technical Assistance Centre)
is protected by access key (see “Power board calibrations”).
The menu structure is summarised in the following table:
MENU
MEANING
VALUE
VALUE THAT CAN BE SET
UT01
Set current day or OFF (the chrono-thermostat is completely
deactivated by setting OFF).
Day or OFF
OFF, Mon, Tues, Wed,…..Sun
UT02
Set current time.
Hour
From 00 to 23
UT03
Set current minutes.
minutes
From 00 to 59
UT04
The various parameters tables reserved to Technical
Assistance Centre are accessed by setting one of the access
keys.
-
From 00 to P5
UT05
First program ignition time.
Time
From 00.00 to 23.50 with 10’ steps
UT06
First program switch-off time.
Time
From 00.00 to 23.50 with 10’ steps
UT07
Choice of days first program is to be considered
(program times will be considered by setting ON on day;
program times will not be considered by setting OFF on day).
Day/State
Mon on/off, Tues on/off, Wed
on/off, Thurs on/off, Fri on/off, Sat
on/off, Sun on/off
UT08
Second program ignition time.
Time
From 00.00 to 23.50 with 10’ steps
UT09
Second program switch-off time.
Time
From 00.00 to 23.50 with 10’ steps
UT10
Choice of days second program is to be considered (program
times will be considered by setting ON on day; program times
will not be considered by setting OFF on day).
Day/State
Mon on/off, Tues on/off, Wed
on/off, Thurs on/off, Fri on/off, Sat
on/off, Sun on/off
UT11
Third program ignition time.
Time
From 00.00 to 23.50 with 10’ steps
UT12
Third program switch-off time.
Time
From 00.00 to 23.50 with 10’ steps
UT13
Choice of days third program is to be considered
(program times will be considered by setting ON on day;
program times will not be considered by setting OFF on day).
Day/State
Mon on/off, Tues on/off, Wed
on/off, Thurs on/off, Fri on/off, Sat
on/off, Sun on/off
UT14
Fourth program ignition time.
Time
From 00.00 to 23.50 with 10’ steps
UT15
Fourth program switch-off time.
Time
From 00.00 to 23.50 with 10’ steps
UT16
Choice of days fourth program is to be considered
(program times will be considered by setting ON on day;
program times will not be considered by setting OFF on day).
Day/State
Mon on/off, Tues on/off, Wed
on/off, Thurs on/off, Fri on/off, Sat
on/off, Sun on/off
Set “OFF” in user menu Ut01 to deactivate chrono-thermostat.