KLS Martin marLED E15 - Component Maintenance and Replacement; Replacing the Cardan Suspension



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
V V 1.0 1.0 5959
•• After successful update of the Master DSP close the window by clicking “OK”.After successful update of the Master DSP close the window by clicking “OK”.
•• Unplug programming adapter and activate Power ON / OFF on the lamp.Unplug programming adapter and activate Power ON / OFF on the lamp.
•• Perform functional check by switching on the lamp again.Perform functional check by switching on the lamp again.
6.206.20 Replacing the Cardan SuspensionReplacing the Cardan Suspension
This chapter describes the required steps to replace the cardan suspension, for example inThis chapter describes the required steps to replace the cardan suspension, for example in
cases where there is not enough room height for the installed comfort version.cases where there is not enough room height for the installed comfort version.
Danger of injury by spring arm snapping Danger of injury by spring arm snapping upwards!upwards!
If not secured, the spring arm will snap upwards when removing the lamp body!If not secured, the spring arm will snap upwards when removing the lamp body!
•• Before disassembly of the lamp body parts, secure the spring arm on the bottom.Before disassembly of the lamp body parts, secure the spring arm on the bottom.
WARNINGWARNING