KMS MP25 - Motor + System Diagnostics; Runtime; Over-Revving of the RPM Limiters

KMS MP25(M)/MA25(M) manual Version 4.2
45
3.2.4.4 Motor + system diagnostics
In this page different parameters are displayed from wich
the values have exceeded maximum or minimum, as well
runtime of the ECU etc.
With ‘save logfile’ you can save the diagnostics on your
computer. If the adress isn’t changed the data will be
stored in the KMS Management folder. The name of the log-
file can be changed to whatever you want. Keep the
extension .log.
You can load a previous log-file by selecting ‘open log-file’.
Then select the log-file in the folder where you stored the
loge-file and op open it.
Under ‘reset all diagnostics’ de diagnostic trouble codes
can be reset.
3.2.4.4.1 Runtime
Here you can check the operation times of the ECU and
engine.
Runtime ECU: Indicates how long the ECU was
powered.
Runtime > 500 rpm 1: Indicates the running time of engine
above 500 rpm.
Runtime > 500 rpm 2: Indicates the running time of engine
above 500 rpm.
Under ‘reset runtime > 500 rpm 2’ the runtime > 500 rpm 2 can be reset. The ‘runtime > 500rpm 1’
as well as ‘runtime ECU’ cannot be reset.
3.2.4.4.2 Over-revving of the RPM limiters
In this part you can see how many crank turns the
engine exceeded the rpm limiter.
Rpm limit 200 up to 400 rpm shows how many crank
turns the engine exceeded the limiter by 200 till 400
rpm.
Rpm limit 400 up to 600 rpm shows how many crank turns the engine exceeded the limiter by 400
till 600 rpm.
Rpm limit 600 up to 1000 rpm shows how many crank turns the engine exceeded the limiter by 600
till 1000 rpm.
Rpm limit 1000 rpm and higher shows how many crank turns the engine exceeded the limiter by
1000 or more.
Highest rpm shows the highest rpm that was measured.