KMS MP25(M)/MA25(M) manual Version 4.2
57
4 Programming
Before programming is started, all connections and sensors must be checked. Look at the
communication bar to check the sensors for correct functioning and setting.
If everything is in good working order, the programming of the diagrams can be started.
There are four ways of changing the values shown in the diagrams:
➢ Filling in the data manually
➢ Making changes using potentiometer and button (mapping box)
➢ Changing bar charts using arrow keys
➢ Changing 3D graph
4.1 Manual changing
By checking a control box, the relevant parameter can be set manually. If a
control box has been selected, an edit menu will appear that allows you to
change the selected values in various ways.
4.2 Bar charts
The columns or rows of the diagrams can also be shown in the form of bar charts. The bar charts
will appear when an engine speed or engine load value is clicked. If an engine speed is clicked, a
bar chart will appear showing all the values related to that engine speed.
If an engine load value is clicked, a bar chart will appear showing all the values related to that
engine load value. Access to the bar charts can also be obtained by pressing the ALT + C keys or the
ALT + R keys simultaneously. The thin yellow line in the graphs of the injection diagram indicates
the maximum duration of injection for the engine speed concerned. If the yellow line is exceeded,
injection time overflow occurs (see section 3.2.4.4.11 Overflow injection time)
It is also possible to modify the diagram values in the bar charts by using the arrow keys, or the
arrow keys in combination with the Ctrl or Alt key. The left/right arrow keys can be used to move
through a column or row. When the upward or downward arrow key is used, the value will go up or
down 0.10 with each touch of the key. If the Alt key is pressed simultaneously, the value will
change 0.01 per touch and if instead of the Alt key the Ctrl key is pressed, the value will change
1.00 per touch.
To Next Page
Loading...
