KMS MP25(M)/MA25(M) manual Version 4.2
5
WARNING:
Disconnect the battery cables when you’re doing electrical work.
Disconnect the KMS ECU from the wiring harness connector when
welding on the vehicle.
Make sure there are no fluid leaks and all connections are secured
and/or tightened.
Wiring and fuel system components must be mounted away from
heat sources or shielded if necessary.
Do not use a batterybooster or a 24V charger. Do not reverse the
polarity of the battery or the charging unit. Do not change the
battery with the engine running. The peak power supply could
severely damage the KMS ECU and other electrical devices.
Avoid open sparks and flames near flammable substances.
Do not use unsuppressed spark plugs and leads. They can cause
electromagnetic interference.
To Next Page
Loading...
