10 A-61931 April 2021
2 Installation
Additional set up steps for S2060w/S2080w
In addition to the above steps from the Installation Guide, you will need
to configure the scanner’s network settings using the scanner’s display.
The Language selection screen will be displayed, unless the scanner
was previously configured. If the scanner was previously configured,
you can reset the scanner so it will start this set up again:
-Press on the scanner’s display to open the Settings menu.
-Scroll down to “Reset”, then press it.
-Follow any prompts.
NOTE: The Settings menu can also be used to change individual
network and power settings.
To navigate through the scanner’s display set-up screens, make your
selection(s) and then press the right arrow to go to the next
screen/step. To go back to the previous screen/step, press the left
arrow .
There are three main set up paths:
• “Setup Wizard” – Allows you to use the scanner’s display to set up
the scanner for three common configurations. This is a good choice
for a small company or small group. The choices are:
- Wired Network: USB is also available, but Wireless access is
turned off/disabled.
- Wireless Network: USB is also available, but the wired connection
is turned off/disabled.
- USB Only: both Wireless or Wired access is turned off/disabled.
• “Scan EasySetup Document” – Allows you to scan a previously
created EasySetup configuration document. This is more suited for a
large installation where a system administrator can set up the
parameters for uniform use across the company or multiple sites.
To create an EasySetup configuration document, go to https://
easysetup.alarisworld.com and follow the instructions. You can then
print the PDF for your use, or e-mail the PDF to your users.
• “Advanced” – Allows you to have full control over all the network
settings. This is appropriate when the “Setup Wizard” combinations
are not sufficient and EasySetup is not desired.
NOTE: You can cancel out of the network set up process by pressing
the button on the scanner. If you cancel, the scanner will use the
default network settings: Wired Network is turned on/enabled in
automatic (DHCP) mode, Wireless is turned on/enabled in Access
Point mode, and USB is available.
To Next Page
Loading...
