A-61931 April 2021 15
2 Installation
Web Browser
Follow these steps to update your scanner’s firmware via the scanner’s
internal web page. You will do this using the web browser from a
computer that is on the same network as the scanner.
NOTE: This is only available for S2060w and S2080w scanners that
have at least one network connection turned on/enabled. Networking is
turned on/enabled by default.
1. Go to your scanner’s product support website:
www.alarisworld.com/go/S2000winstall
2. Scroll to the Firmware section that matches your scanner’s model
name.
3. Select the “Web Browser (.sig)” file to download.
4. Make sure your scanner is turned on and available on the network
and not showing any errors.
5. Obtain the scanner’s network IP Address:
-Press the button to display the Information menu on the
scanner’s display.
-Scroll down to the appropriate IP Address. If you will connect via
the wired network, then use the IP Address under “Wired Address:”.
If you will connect via the wireless network, then use “Wireless
Address:”.
-Press the button to exit the Information menu.
6. Open a web browser on the computer and do the following within
the web browser:
-Enter the scanner’s network IP Address to get to the scanner’s
internal web page.
-Click the ‘Support’ tab.
-Click the “UPDATE SCANNER FIRMWARE” button; it is in the
lower left corner.
-Click the ‘Browse’ button.
-Navigate the folder, on the computer, that you downloaded the *.sig
file to.
-Select the *.sig.
-Click the “Start Firmware Update” button.
-Wait for the firmware update to complete. It may take several
minutes.
To Next Page
Loading...
