A-61931 April 2021 11
2 Installation
Install ferrite core (Ethernet only for S2060w/S2080w)
If you are using an Ethernet cable, you will want to install the provided
ferrite core. Without a properly attached ferrite core, the scanner may
cause interference to nearby wireless devices.
1. Open the ferrite core that came with the scanner.
2. Wrap the Ethernet cable around the ferrite core as shown. Place it
approximately 3 in./7.6 cm from the end of the Ethernet cable that
will be plugged into the scanner.
3. Close the ferrite core, being careful not to pinch the Ethernet cable.
To Next Page
Loading...
