32 A-61931 April 2021
3 Scanning
Enhanced stacking, to maintain order in output stack
Using the tilt stand may be especially helpful with enhanced stacking.
To enable enhanced stacking, refer to the TWAIN or ISIS driver help or
set-up guides. Set-up guides are available on the support page for your
model. For a list of support page links, see “Active Feeding” on
page 31.
Lightweight paper
Straighten the stack of input paper, then fan pages, before placing them
in the feeder, lead edge first.
Do not push lightweight paper too far into the input tray. The scanner
needs to detect the pages, but pushing too far may crumple delicate
paper.
For pages less than 7.2 lb/27 gm
2
weight, set Active Feed to None (go
to the TWAIN Settings > Device - Transport tab).
NCR paper
“No carbon required” (NCR) paper is coated with chemicals that affect
the scanner rollers and can degrade scanner feeding performance.
After scanning NCR paper you should clean the scanner. See
“Cleaning procedures” on page 40.
Scanning small items
If you are scanning small items such as a driver’s license or credit card
— especially hard cards that are relatively thick — they should be
scanned with the embossed side up and ideally one at a time. You may
need to assist them by hand.
One card may be scanned first in a batch with larger pages.
Feed hard cards in landscape orientation.
To Next Page
Loading...
