46 A-61931 April 2021
4 Maintenance
Cleaning the imaging area
1. Wipe the upper and lower imaging area using a Brillianize Detailer
wipe (Step 1) or Staticide wipe. Be careful not to scratch the imaging
area when cleaning.
IMPORTANT: Staticide wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the Safety Data Sheet for more information.
2. Wipe the upper and lower imaging area again using a Brillianize
wipe (Step 2) or an almost dry Staticide wipe to remove any streaks.
3. When finished, close the scanner cover.
Replacement procedures
Kodak Scanners use replaceable feed roller modules that can feed a
wide range of document types, sizes and thicknesses. Operating
environment, document type, the condition of pages being scanned, the
frequency of cleaning paper path and tires, and not following the
recommended schedule for changing the feed roller module can cause
the life of consumables to vary. Change the feed roller module if you
notice an increase in multiple feeds or stoppages, or a decrease in
feeder performance that is not resolved by following the cleaning
procedures.
NOTES:
• Before replacing parts, disconnect the electrical power.
• Certain paper types (such as carbonless paper or newsprint), failure
to clean regularly, and/or use of non-recommended cleaning solvents
can shorten roller life.
To Next Page
Loading...
