14 A-61931 April 2021
2 Installation
Update scanner’s firmware
Use one of the following methods to update your scanner’s firmware:
• Computer with driver software installed – Use this option when the
computer already has the driver software installed and it is connected
to/can access the scanner.
• Web Browser – You have a S2060w or S2080w that has at least one
network connection turned on/enabled, and you have a computer
that is on the same network as the scanner.
Computer with driver software installed
Follow these steps to update your scanner’s firmware from a computer
that already has the driver software installed.
The scanner must be connected/available to the computer. If you can
scan from the computer, then it can be used to update the scanner’s
firmware.
1. Go to your scanner’s product support website:
S2040/S2050/S2070:
www.alarisworld.com/go/S2000install
S2060w/S2080w:
www.alarisworld.com/go/S2000winstall
2. Scroll to the Firmware section that matches your scanner’s model
name.
3. Download the firmware installer that matches your computer’s
Operating System.
4. Make sure your scanner is turned on, is connected/available to your
computer and not showing any errors.
5. Run the firmware installer.
6. Follow the steps of the firmware installer.
To Next Page
Loading...
