Kodak CR 7400 User Manual

INSTALLATION INSTRUCTIONS
12 September 2007 – 6H4130
Installing the Kodak CR 7400 driver for the WINDOWS Vista Operating
System
After you install the software, keep the user interface software CD-ROM in the computer disk drive and install the
Kodak CR 7400 driver as described below:
[1] Connect the power cable to the back of the Kodak CR 7400 unit.
Back view of unit
[2] Connect the power cable to the main outlet.
[3] Power on the unit by turning the on/off switch to “on.”
[4] Connect the USB2 cable from the unit to the computer. The Update Drive Software - Unknown Device screen
appears.
[5] Select Browse my computer for drive software. The Found New Hardware - Unknown Device screen
appears.
[6] Select Browse my computer for driver software (advanced). Indicate where to search for the software,
usually E:\Driver (where E: is the CD drive), and click Next. The driver software is installed.
[7] When the installation is complete, click Close. This completes the software installation for the Kodak CR 7400
unit. Proceed to the KODAK CR 7400 System Setup.
Fuse for erase lamps
On/off switch
Power cable connection and main fuse
USB connection

Kodak CR 7400 Specifications

General

Brand	Kodak
Model	CR 7400
Category	Medical Equipment
Language	English