6H4130 – September 2007 13
Installing the Kodak CR 7400 driver for WINDOWS 2000 and WINDOW XP
Operating Systems
After you install the software, keep the user interface software CD-ROM in the computer disk drive and install the
Kodak CR 7400 driver as described below:
[1] Connect the power cable to the back of the Kodak CR 7400 unit.
Back view of unit
[2] Connect the power cable to the main outlet.
[3] Power on the unit by turning the on/off switch to “on.”
[4] Connect the USB2 cable from the unit to the computer. The Found New Hardware Wizard appears.
Found New Hardware Wizard
[5] Select No, not this time and click Next. The following screen appears:
Fuse for erase lamps
On/off switch
Power cable connection and main fuse
USB connection
To Next Page
Loading...
