Troubleshooting
November 2014 5-3
Out of paper The paper is empty or is not loaded
correctly. Automatic loading failed.
Load (or reload) the paper (see page 2-8).
Set Paper The paper is empty or is not loaded
correctly.
Load (or reload) the paper (see page 2-8).
Take Out Paper The printer detected the end of the
paper and ejected the remaining
paper.
Load new paper (see page 2-8).
Ready Loading The printer is preparing to load paper. No action is necessary.
Paper jam The paper is jammed in the paper
path.
Clear the paper jam from the paper path
(see page 5-6), then reload the paper.
If the error persists, turn the printer off
and then on again.
7011 - MECHA
ERROR
There is a paper jam at the slitter. Clear the paper jam from the exit path
(see page 5-11). If the error persists, turn
the printer off and then on again.
Message Description or Cause Possible Solution
To Next Page
Loading...
