2-12 November 2014
Setting Up the Printer
14. Wait for the blank sheets to exit the printer.
15. Insert the exit tray waste bin into the exit tray.
16. Install the exit tray.
Making a Test Print
Make a test print to check that the printer is installed and set up
correctly.
1. On the operator panel, press Menu until Printer_Info appears.
2. Press + until Te s t _ P r i n t s appears.
3. Press Enter.
4. Press + until the desired type of test print appears.
5. Press Enter to start printing the test print.
6 . To e x i t Te s t P ri nt M o d e, pr e s s M en u u n t i l Ready 8 x 10 or
Ready 8 x 12 appears.
For more information on using the operator panel in Setup mode,
see “Printer Settings” on page 4-3.
To Next Page
Loading...
