2-12
To reactivate your camera from the sleep mode:
✔ In the Review mode, press the DISPLAY button.
✔ In the Capture mode, use the ZOOM or SHUTTER as you normally
would to take a picture.
Installing batteries
To install the batteries:
WARNING: When using batteries, limit the continuous operation of the LCD
for previewing pictures to less than 30 minutes. This is
particularly true with Lithium batteries. Previewing pictures
requires a significant electrical current, which over time could
cause your batteries to heat up significantly. Should your camera
become too hot inside, it is designed with protective circuitry to
turn itself off. You should allow sufficient time for the camera to
cool before turning it on again. Consider using an AC adapter
when using preview mode for extended periods.
Always follow your battery manufacturer's directions fully.
1 Open the battery door.
2 Slide the inside battery cover toward the back
of the camera and then lift it away from the
camera.
3 Insert the batteries as indicated on the battery
cover.
4 Close and lock the inside battery cover and
close the battery door.
To Next Page
Loading...
Need help?
General
