2-4
Your camera display
On the top of the camera a display shows the current settings. Take a minute to
become familiar with the various entries on the display. The following
subsections briefly describe each entry.
☞ The camera must be turned on to view the Status Display. You must also be
in the Capture mode to view and interact with this display.
☞ For information on how to define settings through the Capture Mode menus
and through the SCROLL and SELECT buttons, refer to Chapter 3.
Flash
Your camera is equipped with a built-in flash that offers a red-eye reduction
feature. The flash has an effective range of approximately 1.6 to 9.8 ft. (0.68 to 3
m). There are four Flash settings:
Auto— the flash fires automatically when you press the SHUTTER
button and the camera determines that there is not enough light.
Red-eye— if the camera determines that there is not enough light,
the flash fires once when you press the SHUTTER button to reduce
the chance of red-eye and then flashes a second time, 600
milliseconds later, when the picture is taken.
Flash
Quality
Close up (DC220
Self-timer
Battery
Pictures
status
remaining
Exposure
compensation
Picture
type
Set using the
hardware buttons
A read only displayA read only display
Set using the
hardware buttons
Set using the
SCROLL and
Set using the
or Capture Mode
or Capture
Set using the
hardware buttons
or Capture
InfraRed
communication
A read only display
Manual mode
Set using the
Capture Mode
menus
Mode menus
menus
Mode menus
only)
SELECT buttons
SCROLL and
SELECT buttons
Set using the
SCROLL and
SELECT buttons
To Next Page
Loading...
Need help?
General
