3-13
3
Taking pictures
DeÞning settings via the SCROLL and SELECT buttons
Its likely that you’ll change these settings much more often than the settings that
you define through the settings menus. The settings can change from picture to
picture depending on the conditions that exist at the time.
☞ You must be in the Capture mode to change these settings.
Setting Flash, Exposure, Picture Type, and Quality
To change the Flash, Exposure, Picture Type, and Quality Capture mode settings:
Setting the Self-Timer and Close-up settings (DC220 only)
To activate the Self-Timer and Close-up settings:
1 Press the SCROLL button to scroll through
the first four functions on the Status
display: Flash, Exposure, Picture Type, and
Quality.
2 When the function you want to change is
flashing, press the SELECT button to
toggle through the choices for the active
function.
The new selection takes affect if you press
the SCROLL button again to move to
another function or if you do not press a
button for 5 seconds.
1 Press the TIMER button:
✔ once to activate the self-timer
✔ twice to activate the close-up setting
✔ three times to activate both settings
✔ four times to turn both settings off again
☞ On the DC260, activate the self-timer
by pressing the TIMER button.
To Next Page
Loading...
Need help?
General
