www.kodak.com/go/aiosupport 25
KODAK ESP 7 All-in-One Printer
NOTE: In your setup, instead of <Network name> as shown in the illustration above,
the LCD will show the actual network name (SSID), without the brackets,
and the signal strength, displayed as a percentage, of each available Wi-Fi
network within range.
4. With the desired network selected, press
OK. You may need network
identification information, such as a security string, in order to authenticate your
connection.
NOTE: You will need to know the network name (SSID) of the Wi-Fi network and its
security string to connect your printer to the network successfully. Contact
your Internet provider or the person who helped you configure your network
to assist you.
5. If you are looking for a Wi-Fi network that does not broadcast its SSID, see
Connecting to an unlisted network, page 26.
NOTE: If your printer was last connected to an available network on the list, the
network settings are saved and the printer will automatically attempt to
reconnect you to that network.
6. If the network requires the entry of a security string, the keyboard will be shown
on the LCD. Press , , or to select a key. Press
OK.
7. Enter the security string. The correct upper and lower case characters and
numbers are required.
NOTE: To erase any letters or numbers entered in error, select
<BKSP > (backspace)
and press
OK.
Key/Passphrase/
Security String
Description
WEP key 5 or 13 ASCI characters; case-insensitive
or
10 or 26 Hexidecimal digits; case-insensitive
WPA/WPA2 phrase 8-63 printable ASCI characters; case-sensitive
To Next Page
Loading...
Need help?
General
