Kodak ESP 7 - Printing Multiple Photos; Printing Panoramic Photos

www.kodak.com/go/aiosupport 43
KODAK ESP 7 All-in-One Printer
NOTE: Before you can transmit photos to your printer from a Bluetooth–enabled
device, you must first “pair” the printer and the device so that they can
communicate. This “pairing” is performed from your device’s interface.
Review the instructions for pairing that came with you Bluetooth–enabled
device, as needed.
When the device is searching for other Bluetooth-enabled devices to pair
with, if your printer is within range of the device (see Range below), your
printer will appear in the list, with a name starting with
ESP. (Your device may
allow you to rename it, as appropriate.)
If your device prompts you for the printer’s personal identification number
(PIN) to authenticate and initiate the connection, enter
1111.
Bluetooth devices do not use a Print command. You must use the device’s Send
function to transmit an image stored on it to the printer. Only one file can be sent
from the device at a time. Once received, your printer will print the image
automatically using the default settings.
Range
When the device and the printer are connected, you can send photos from your
Bluetooth device to the printer. Your printer supports connectivity to one Bluetooth
device at a time.
For the highest transfer speed, Kodak recommends keeping a maximum distance of
10 meters (32.8 feet) between Bluetooth devices, as they may not work reliably
beyond this range.
Printing multiple photos
When you select a print size that is smaller than the paper size, this printer
automatically lays out multiple photos using the least amount of space, minimizing
paper waste when separating the photos.
Printing panoramic photos
You can print a panoramic photo on 4 x 12 paper, or two panoramic photos on U.S.
letter or A4 paper; some cropping will occur.