Kodak ESP 7 - Configuring Photo Print Settings

Viewing and Printing Photos
38 www.kodak.com/go/aiosupport
Most memory cards will work with this printer. When you insert a memory card, or
connect a camera or portable flash drive to the printer, the last photo taken is
displayed first.
CAUTION:
Do not insert more than one device, such as a USB thumb drive or memory
card, into the printer at a time, or you will get an error message. Also, never
remove or disconnect a memory card from its slot unless the blue light near
the slot is not blinking.
NOTE: Photos stored on a PictBridge camera are displayed on the camera’s LCD
screen only. See Printing photos from a PictBridge camera, page 40, as
needed.
Configuring photo print settings
You can change the factory default print settings for your printer using the control
panel. Windows users may adjust some settings using Home Center software (see
Home Center Help, discussed in Home Center Software, page 17, for information on
using Home Center).
1. Insert a memory card into the appropriate slot, or plug a USB flash drive or
(PTP) digital camera to the front panel USB port. The last photo is displayed
first.
2. From the control panel, press
Menu.
3. Press until the option you want to configure is selected, and then press
OK.
4. As needed, press or to change the setting.
5. Press
OK to save the setting for the current print job.
6. To save the setting as the default value, select
Save as Default and press OK.
7. As needed, press or until
View Photos is selected in the Print Photos menu,
and then press
OK to return to viewing and selecting photos for printing. Or,
press
Start to print the selected photo(s) with the selected settings.