Troubleshooting
82 www.kodak.com/go/aiosupport
To see if you have an active network connection
Check the two Ethernet indicator lights on the top and bottom of the RJ-45 Ethernet
jack on the back of the printer. The lights indicate the following:
To establish an active network connection
1. Check the cable connections from the All-in-One printer to your gateway,
router, or hub to ensure connections are secure.
2. If the connections are secure, turn off the power on the All-in-One printer, and
then turn it on again. Press the
On/Off button on the control panel to turn the
printer off, and press it again to turn it back on. Also, turn off the power on your
router or hub, and then turn it on again.
No TCP/IP
Probable Cause
Your Local Area Network (LAN) card is not installed properly.
Corrective Action
Make sure your LAN card is installed properly and set up for TCP/IP. See the
instructions that came with your LAN card.
Printer not found
Probable Cause
The All-in-One printer is not turned on.
Corrective Action
Tu r n o n t h e p ri nt e r.
Probable Cause 2
You do not have an active network connection.
Corrective Action
Make sure you have an active network connection.
Top light If this light is a solid green, the device is properly
connected to the network, and communications have
been established. If the top light is off, there is no
network connection.
Bottom light This yellow light flashes when data is being sent or
received by the device over the network.
To Next Page
Loading...
