www.kodak.com/go/aiosupport 89
KODAK ESP 7 All-in-One Printer
The WEP key index setting of your access point does not match the WEP key index
setting of the All-in-One printer.
Corrective Action
The printer is looking for a WEP key index of 1. If the WEP key index setting was
changed on the access point, open the Embedded Web Server for the printer and
update the index setting to match the index setting of your access point. Once
you've updated the index setting on the printer, repeat the setup procedure.
NOTE: Some access points provide more than one WEP key. Make sure you use the
first WEP key (index 1) when setting up your wireless network.
Invalid WPA Passphrase
Probable Cause
You have entered the WPA passphrase incorrectly.
Corrective Action
Enter the correct passphrase. Make sure it has between 8 and 63 characters, and
matches the passphrase programmed in the access point (case sensitive).
Another device connected to the access point
Probable Cause
Another device in the vicinity connected to your access point before the All-in-One
printer was able to connect.
Corrective Action
Cancel the setup and start over.
To Next Page
Loading...
