Printer Overview
6 www.kodak.com/go/aiosupport
Configuring printer settings
NOTE: When you first power on the printer, the LCD prompts you to select the
Language and Country/Region.
To set or change basic printer settings:
1. Press Home.
2. Press to select Printer Settings, then press OK.
3. Press to select one of the following settings:
• Date and Time
–Press OK, then press to select Ye a r , Month, Day, Hour, or Minute.
– Press or to change the values; press OK when you are done.
–Press Back to return to the Printer Settings menu.
• Ti m e t o L o w Po w e r
To conserve energy, your printer will enter a low power (sleep) mode after
being idle for a default delay time of 1 hour. You can increase the delay time to
low power (in 0.5 hour increments) up to 4 hours. Increasing the delay time
may result in reduced energy savings.
– Press to change the time to energy-saving sleep mode (select from 1 to
4 hours in 0.5 hour increments).
• Tagged Images Printing (see Printing tagged pictures, page 55)
– Press to select Off or On.
• Language
–Press OK, press to select a language, then press OK.
• Country/Region
–Press OK, press to select a country or region, then press OK.
• Reset All Settings (see Resetting factory defaults, page 114)
NOTE: Resetting factory defaults does not change the date and time,
language, country/region, or network settings.
• Printer Info
–Press OK to view the Firmware Version number; press OK when you are
done.
4. Press Back to return to the Main Menu.
To Next Page
Loading...
