62 www.kodak.com/go/aiosupport
7
Copying
You can copy documents and photographs with your all-in-one printer. The printer
produces high-quality color or black-and-white copies on a variety of paper types
(see Paper types, page 38).
Loading originals for copying
You can copy multiple-page, one- or two-sided documents automatically by loading
the originals (up to 35 pages) face up in the Automatic Document Feeder (ADF).
IMPORTANT: The ADF accepts plain paper originals from 6.9 to 8.5 in. (18 to 22 cm) wide
and 9.8 to 14 in. (25 to 36 cm) long.
To copy a photo, documents on thick paper, or a document that is too small or too
large to fit in the ADF, place the original face down on the scanner glass.
For more information on loading originals, see Loading originals, page 45.
Copying a document
You can copy a document using the default settings, or you can adjust the quantity,
size, quality, and brightness of your copies.
Using the default settings to copy a document
The default settings are either the factory default settings (see Resetting factory
defaults, page 114), or defaults that you have set on the printer (see Save as Defaults
at the bottom of the table under Adjusting the settings and copying a document,
page 63).
To copy a document using the current default settings:
1. Place the original document in the ADF or on the scanner glass.
2. Press
Copy.
3. Press
Start Black to make a black-and-white copy, or press Start Color to make a
color copy.
NOTE: If you load the original document in the ADF, the ADF automatically feeds
the document into the printer when you begin copying.
To Next Page
Loading...
Need help?
General
