KODERA CASTING C370G - Divide Strip

17
《Basics》 screen at 《Divide Strip》 Select 《Divide Strip》 at 《Motion》 screen
（P.13-⑥）.
When stripping can’t be performed because of the adherance of the core wire or long
stripping, it is done by dividing.
①《Front Strip Length》：Setting of the stripping length of the front side insulation.
②《Front Half Strip Length》：Setting of the half-stripping length of front side of the wire.
③ Setting the 「 Divide Strip Length 」of the fornt side insulation ：
Input each stripping length (mm) to divide.
④《Total Length》：Setting of the cutting length of the wire.
⑤《Rear Strip Length》：Setting of the stripping length of the rear side insulation.
⑥《Rear Half Strip Length》：Setting of the half stripping length of rear side of the wire.
⑦Setting the 「Rear Divide Strip Length」of the rear end insulation ：
Input each striping length (mm) to divide.
Unit:
0.1mm
Divide strip processing,
please be sure to enter
the Half-strip length.
If you enter "0" to the
Half strip length, the
processing won't be
divided and will be
normal strip.
The remaining length that is not divisible against
strip length will be added to the end piece of the
divide strip finally.