KODERA CASTING C371A - In Case of Tube or Cutting Only; Pressure Adjustment; When Taking out the Wire after Finishing the Processing

22
5. In case of tube or cutting only
Input 《Total Length》 only, and 《Front Strip Length》, 《Front Half Strip Length》, 《Rear Strip
Length》 and 《Rear Half Strip Length》 shall be all “０”
Any numerical values are acceptable for 《Core Diameter》 and 《Blade Move Back》.
Setting of the pieces and gap adjustment are required.
6. Pressure adjustment
Increase the pressure of the roller when the wire is especially stiff or it is difficult to strip the
insulation off.
Pull and turn the pressure adjustment knobs which are located both sides on the front panel.
The larger numerical number is the stronger pressure.
7.When taking out the wire after finishing the processing.
Turn the roller ＵＰ／ＤＯＷＮ tab on the mechanical section to up the roller and take out the
wire.
Note： Take out the wire when it’s not processed. Because the wire may be transformed if
the wire is pinched by the feeding rollers for a long time.