KODERA CASTING C371A - Replacement of Guide Pipe; Replacement of the Guide Wire; Replacement of Blades

23
A
8.Replacement of Guide Pipe
・Demount Loosen screw Ａ, and pull it out to the operator’s side.
・Mount Fix the guide pipe so that the knock pin is inserted
into the knock hole and fasten Screw A.
（See Fig.1）
9.Replacement of the Guide Wire
・Demount Loosen screw Ａ and pull it out to the right side.
・Mount Fully insert the wire guide so that Ａ fits in the
grooves of the wire guide.
（See Fig.2）
10.Replacement of Blades
Handle the blades with careful attention.
It may cause injuries.
・ Remove screw Ａs and the cutter block.
Pull it out to your side gently and horizontally because the knock pin is
inserted.
（See Fig.3）
・ Remove screw Ｂ and take the lower blade out first.
（See Fig.4）
Knock pin
Fig. 1
A
A
Fig. 3
Lower cutter
Ｃ
B
Fig. 4
Fig.2