KODERA CASTING C371A - Basics》 Screen at Sheath Strip (Outside Insulation Half Stripping)

17
《Basics》 screen at Sheath Strip (outside insulation half stripping)
Select ⑨ on the 《Motion》 screen （P. 11）.
At above figure, half-stripping scene is displayed so that setting becomes easily
understandable. But it is not displayed on the screen of the device.
①《Front Strip Length》：Setting of the stripping length of the front
side insulation.
②《Front Half Strip Length》：Setting of the half-stripping length
of the front side outside insulation.
③Setting of the stripping length of the front side outside insulation
④《Total Length》：Setting of the cutting length of the wire.
⑤《Rear Strip Length》：Setting of the stripping length of the rear side
insulation.
⑥《Rear Half Strip Length》：Setting of the half-stripping length of
the rear side outside insulation.
⑦Setting of the stripping length of the rear side outside insulation.
⑧《Core Diameter》：Depth of the blade at A when striping insulation.
(See P,8)
⑨《Blade Move Back》：Blade’s move back at A when stripping the
insulation. (See P.9)
⑩Depth of the blade at B when stripping the outside insulation. (See P.8)
⑪Blade’s move back at B when stripping the outside insulation. (See P.9)
Unit:
0.1mm
Unit:
0.01mm