KODERA CASTING C371A - Operation Panel; Basic》 Screen Standard Processing

6
4. Operation Panel
《Basic》 screen Standard Processing
When not selecting ⑤～⑨ on the 《Motion》 screen（P.11）.
①《Front Strip Length》：Setting of the stripping length of the front
side insulation of the wire.(Input range 0.1~999)
②《Front Half Strip Length》：Setting of the half stripping length
of front side of the wire. (Input range 0.1~999)
③《Total Length》：Setting of the cutting length of the wire.
④《Rear Strip Length》：Setting of the stripping length of the rear side
Insulation of the wire. (Input range 0.1~999)
⑤《Rear Half Strip Length》：Setting of the half stripping length
of rear side of the wire. (Input range 0.1~999)
⑥《Core Diameter》： Depth of the blade when stripping the wire.
(See P,8) (Input range 0.01~10)
⑦《Blade Move Back》：Setting of the blade back when insulator is
stripped. (See P,9) (Input range 0.01~3)
⑧《Total Length Correction》：When “Set Total Length” and “Actually processed
total length of the wire” are different, correct it here.
0：No correction
For example)
Set Total Length
Actual Total Length
Correction
amount
○
ａ
1000mm
997mm
In this case
3mm
3
input
○
ｂ
1000mm
1005mm
In this case
－5mm
－5
input
⑨《－》：Minus key. When correcting the numerical value adversely at ⑧.
《－１》：Minus 1 key. The current number (quantity of wire to be processed) will
be reduced by －1.
⑩《Setting Pieces》：Setting of the pieces to be processed.
Unit:
0.1mm
Unit: 0.01mm