⑪《Current Pieces》：Processed pieces of the wire.
During processing, number of the 《 Current Pieces 》（processed pieces ） is
increasing every second.
When you want to clear the displayed number to “0”, press 《Current Pieces》
［0］［SET］.
⑫《Batch Pieces》：Number of bundles For example, you can set this when you need
20 bundles of 50pieces totaling 1000 pieces.
《Setting Pieces》 ［1］［0］［0］［0］［SET］
《Butch Pieces》 ［5］［0］［SET］
・ Each time the set number of batch pieces is completed, the device stops
automatically.
When it stops, press ［START］ to process the number of batch pieces again.
As the processing proceeds, the display indicates the counter as follows:
1／ 50
2／ 50
3／ 50
・When you want to stop batch processing, press 《Batch Pieces》［0］［SET］ to cancel.
⑬Sec.：By inputting the time, you can set the automatic start of the batching. After
processing the specified number of pieces, the device stops for the length of time specified
here and then starts again automatically. Unit：second
⑭《Thin Wire》：By narrowing down the blade’s opening size, the processing speed
will be faster.
⑮《Wire Sensor》： Setting of the detection of the wire (presence of the wire) with the left
roller gap.
⑯《Up》：Use this function when an optional left roller UP/DOWN machine is attached.
Only when you select 《Rollup 2》 key on P.11, it is displayed.
⑰《Up》：Use this function when an optional right roller UP/DOWN machine is attached.
Only when you select 《Rollup 1》 key on P.11, it is displayed.
To Next Page
Loading...