EasyManua.ls Logo

KODERA CASTING C371A - 1.Name and Motion of the Components on the Front Panel; Explanation of Components on the Operation Panel

KODERA CASTING C371A
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
1
.
Name and Motion of the Components on the Front
Panel
Name of the
components
①Left side knob for roller UP/DOWN
⑧Upper left roller
②Right side knob for roller UP/DOWN
⑨Lower left roller
③Left side roller gap adjusting dial
⑩Lower right roller
④Right side roller gap adjusting dial
⑪Upper right roller
⑤Sensor signal lamp for wire detection
⑫Cutter block
⑥Left side knob for roller pressure adjustment
⑬Guide pipe
⑦Right side knob for roller pressure adjustment
⑭Left side wire guide
⑮Right side wire guide
2. Explanation of Components on the Operation Panel
Explanation of
components
(A)Setting screen
The keys of this setting
screen are displayed in
parentheses 《 》.
(B)POWER・・・Power ON/OFF switch button
-
(C)Keys for numerical value setting ( Ten keys)
The keys of this setting
screen are displayed in
parentheses [ ].
Keys for numerical value setting from [0] to [9]
[ .] ・・When the numerical value less than 0 is input
[SET] ・・When all numerical values are stored
(D)START・・・Start key (Start operation)
(E)STOP・・・Stop key (Work cycle, alarm and error sounds stop)
(F)E.STOP・・・E.Stop key (Emergency stop)
(G) Emergent Shut Down Switch・・・The Power will be OFF.
-

Related product manuals