Kohler Courage SV470 - Install Air Cleaner Element, Precleaner, and Air Cleaner Cover

10.23
Section 10
Reassembly
10
Install Air Cleaner Element, Precleaner,
and Air Cleaner Cover
1. Install the air cleaner element with the pleated
side “out.” Seat the rubber seal onto all the edges
of the air cleaner base. See Figure 10-80.
Figure 10-80. Installing Air Cleaner Element.
2. Install the precleaner (if so equipped), into the
upper section of the air cleaner cover. See Figure
10-81.
Figure 10-82. Installing Air Cleaner Cover.
Install Muffler
1. Install the gasket, muffler, and hex flange nuts
on the exhaust port studs. Leave the nuts slightly
loose.
2. If an auxiliary muffler bracket is used, install the
M6 hex flange screw(s) into the bracket.
3. Torque the hex flange nuts to 24.4 N·m
(216 in. lb.). See Figure 10-83. Torque the screws
to 7.5 N·m (65 in. lb.).
Figure 10-81. Installing Precleaner.
3. Install the air cleaner cover and secure with the
two retaining knobs. See Figure 10-82.
Figure 10-83. Torquing Exhaust Flange Nuts.