Kohler Courage SV470 - Remove the Valve Cover and Cylinder Head

8.7
Section 8
Disassembly
8
Figure 8-24. Removing Fan and Flywheel Mounting
Hardware.
3. Carefully li the cooling fan to disengage the two
drive pins and remove it from the flywheel.
4. Remove the flywheel from the cranksha using a
puller. See Figure 8-25.
NOTE: Always use a puller to remove the
flywheel from the cranksha. Do not
strike the cranksha or flywheel, as they
could be cracked or damaged.
Figure 8-26. Removing Stator.
Remove the Valve Cover and Cylinder Head
1. Remove the seven screws securing the valve cover
and any aached brackets. See Figure 8-27.
Figure 8-27. Removing Valve Cover Screws.
2. Remove the valve cover and gasket from the
cylinder head. See Figure 8-28.
Figure 8-25. Removing Flywheel Using Puller.
5. Remove the flywheel key from the crank sha.
Remove the Stator
1. Remove the two screws securing the stator to the
closure plate bosses. See Figure 8-26.
NOTE: To disconnect the B+ or stator leads from
the wiring harness connector, insert a
small screwdriver, or similar narrow flat
blade, and bend down the locking tang
of the terminal(s). Gently pull the lead(s)
out of the connector.
Figure 8-28. Valve Cover and Gasket Details.