22
Bin Full Adjustment: To increase the temperature at which the ice level probe reacts to contact
with ice in the bin turn the dial clockwise. To decrease, turn the dial counterclockwise. The
temperature range for this adjustment is between 33 and 45F.
Note: After adjustment the controller must be reset.
Switch Input Port: For the on/off, ice/clean and limit switches
Factory Use Only: Used to display diagnostic codes to a LCD monitor used only by service the
factory.
Output: AC output for powering the fan(s), compressor, water pump(s), actuator motor(s),
Contactor(s) and valves.
To Next Page
Loading...
