14
5-1 Checking the game performance
5 Game settings
When the power switch is turned ON after installation of machine, the performance
of game Printed Circuit Boards (PCB) is checked automatically and the result is
displayed on the screen. If the power is not turned ON, make sure that the main
power switch and sub-power switch are both at the ON position. (See page 35)
•Be sure to check the PCB unit (self test) before using the machine.
•Do not change the DIP switch setting of this product to other than factory
setting.
•If an abnormality persists or the machine does not operate properly,
immediately turn OFF the main power switch, unplug the power cord from
the receptacle and contact your nearest dealer.
Result of test
·The machine goes to the game mode and the demonstration game gets started.
If test is OK
· “BAD” appears on the screen, and the checking is repeated.
After the installation of this product or when the PCB unit has been repaired or
replaced, turn ON the power switch while pressing the test button of the service
panel to initialize the setting once to the original factory setting.
At this time, keep pressing the test button until “RTC DATA INITIALIZED. PLEASE
RELEASE TEST BUTTON” appears.
If an abnormal display continues or the machine does not operate normally,
immediately turn OFF the main power switch, unplug the power cord and
contact your nearest dealer.
If any abnormality is detected
To Next Page
Loading...
