AS-11.65.037
22 (40) (A) 2009-10-16
KDL16
Maintenance Instruction
© 2009 KONE Corporation
All rights reserved.
Disclosure prohibited
8 INSTALLATION OF KDL16L DRIVE MODULE
8.1 Tools
Following tools are recommended to be used when replacing the drive module:
• Door blocking tool KM871952
• Safety barriers
• Work stool
• Multimeter
• Torx screwdriver TX10
8.2 Installing new drive module
Step Action Illustration/Note
1 Check the drive module fixings on the shaft
wall, if the new drive module fits to the old
fixings.
Only MRL elevators
2 Attach rail fixings on the shaft wall, if new
fixings are needed.
3 Lift the new drive module into the place.
4 Tighten the fixing screws (A).
Insert and tighten fixing screws (B).
NOTE! Check fixing points of the old drive
module.
The drive module has eight fixing
points for different fixings to guide
rail but only four of them are used.
To Next Page
Loading...