AS-11.65.037
34 (40) (A) 2009-10-16
KDL16
Maintenance Instruction
© 2009 KONE Corporation
All rights reserved.
Disclosure prohibited
APPENDIX D.PROGRAMMING AND ADJUSTING LOAD WEIGHING DEVICE (WR,
MICELECT)
D.1 Programming procedure
NOTE! Before starting the procedure (Zero Calibration), the car should be positioned in the shaft at a
point when it is lightest. The weight of the car is affected by the weight of the roping system
(1:1 or 2:1 roping, compensation chain) and the travelling cable. For example, the car is usually
the lightest: at the bottom floor, in 1:1 and 2:1 roping with compensation chain; or at the
topmost floor, in 2:1 roping without compensation chain.
The LWD display must always show a positive value when the car is at any point of the shaft.
The negative value marking should never appear in the display (dot on the bottom right). After
setup, run the car up and down the shaft to check the weight.
Check the LWD software version.
• If the software version is P-LM3D-025 or newer, continue on D.1.1.
• If the software version is P-LM3D-022, or older, or not marked, continue on D.1.2.
D.1.1 LWD mode (P-LM3D-025 or newer)
Step Action Illustration/Note
1 Check that the control unit display is lit. Energy saving control turns display OFF
after 5 minutes. By pressing any of the
buttons turns the display ON.
2 Ensure that the elevator is in RDF mode.
3 Program the load weighing device.
Press the P button for 3 sec. to begin the
programming. (Refer to the following
programming procedure.)
Press P to accept setting you have chosen.
Press the arrow (up and down) buttons to
change the value of the setting.
Sensor selection
• Display shows “0000”
• Press P.
• Select “CCP” (well known weight).
• Press P.
Zero calibration (“TARE”), with lightest car position (see above):
• Display shows “TARE”.
• Press P button.
• Make zero setting with empty car by selecting “YES”.
• Press P. (The display blinks and beeps for 5 seconds.)
To Next Page
Loading...