Kone KDL16 - Page 37

AS-11.65.037
37 (40) (A) 2009-10-16
KDL16
Maintenance Instruction
© 2009 KONE Corporation
All rights reserved.
Disclosure prohibited
D.1.2 LWD mode (P-LM3D-022, or older, or not marked)
Zero calibration (“TARE”):
• Display shows “TARE”.
• Press P button.
• Make zero setting with empty car by selecting “YES”.
• Press P. (The display blinks and beeps for 5 sec.)
Sensor configuration:
• Select “CCP” (well known weight).
• Press P.
• Add 100% of the rated load to the car.
• Set the elevator rated load (kg) by pressing the arrow buttons (the same load as
above).
• Press P.
Number of passengers:
• Set the maximum number of persons in the car using arrow buttons.
• Press P.
Roping ratio:
• Select roping 1:1 or 2:1 using arrow buttons.
• Press P.
Alarm values:
• Display shows “AL 1” .
• Press P
• Set the rated load of the elevator using arrow buttons.
• Press P.
• Display shows “AL 2”.
• Press P.
• Set the rated load of the elevator using arrow buttons.
• Press P.
• Display shows “AL 3”.
• Press P.
• Set 120% of the rated load of the elevator using arrow buttons.
• Press P.
Compensation chain weight (“CHAI”):
• Display shows “CHAI”.
• Press P.
• Select “NO” using arrow buttons.
• Press P.
Car indicator (“INDI”):
• Display shows “INDI”
• Press P.
• Select “NO” using arrow buttons.
• Press P.
Analogical output (“CURR”):
• Display shows “CURR”
• Press P.
• Select “4-20” using arrow buttons.
• Press P.
Rated load of the elevator is displayed.
1
2
3
4
5
6
7
88