Kone KDL16 - Connections of KDL16 L Drive Module

AS-11.65.037
9 (40) (A) 2009-10-16
KDL16
Maintenance Instruction
© 2009 KONE Corporation
All rights reserved.
Disclosure prohibited
1.8 Connections of KDL16L drive module
NOTE! Cabling order of motor cable (2) and brake / thermistor cable (3) may be swapped if cables are
not long enough.
1. Braking resistor
(XBRE2)
2. Motor (U, V, W)
3. Brake (XBR4) /
Thermistor (XT1)
4. DC-link (XECO2), if
ECB is applicable
5. Control (XECO1), if
ECB is applicable
6. Start permit linking
(XS3A), if ECB is
applicable
7. Terminal for power
supply (T1-T3)
8. Load weighing device
(XW1) / Speed
feedback (XLG1)
9. LCECPU (XL1)
10. Encoder (XMEN5)
11. Brake supply (XS3)
12. Battery back-up (12V)
(XBAT1)
*) Loop the wires at the
connectors. This is to
avoid gravity water
entering to the
connectors.
1 2
3
4
9
5
6
7
8
11
10
12
1064016.wmf
*)
2
3