Konftel 800 - Upgrading Two Expansion Microphones

FEATURES AND ACCESSORIES
The LEDs on the phone turn red to indicate that it is busy with the microphone
upgrade. The expansion microphone LEDs start flashing green.
The phone displays the Upgrade in progress message and shows the
upgrade progress in percentage (0%-100%).
When you connect one Smart Mic to Konftel 800, the phone shows the
upgrade status for Smart Mic 2 as N/A.
Smart Mic 1: 10%
Smart Mic 2: N/A
Optional: To cancel the upgrade, tap No.
In this case, you postpone the upgrade until the phone reboots.
Result
If the upgrade is complete, the microphone LEDs turn off, and Konftel 800 displays
the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: N/A
In 10 seconds, the pop-up dialog window hides, and the phone enters Idle mode.
If the Smart Mic firmware upgrade fails, the microphone LEDs turn off, and the
phone displays the Smart Mic 1: Failed message.
Upgrading two expansion microphones
About this task
Use this procedure to upgrade two expansion microphones connected to your
device simultaneously.
Before you begin
Connect Smart Mic 1 to the first audio expansion port of your conference phone.
Procedure
Connect Smart Mic 2 to your conference phone using the second audio
expansion port.
The LEDs on the phone turn red to indicate that it is busy with the microphone
upgrade. The Smart Mic 2 LEDs start flashing green.
54