Konftel 800 - Terminating Expansion Microphone Upgrade

FEATURES AND ACCESSORIES
A pop-up dialog window provides the expansion microphones upgrade status in
the following format:
Smart Mic 1: 20%
Smart Mic 2: 10%
Optional: Terminate Smart Mic 2 upgrade by detaching the expansion
microphone from the phone.
In this case, you postpone the upgrade until you connect Smart Mic 2 again.
Result
When the upgrade is complete for Smart Mic 1 and Smart Mic 2 is still upgrading,
the LED turns off on Smart Mic 1, and Konftel 800 displays the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: 86%
When the upgrade is complete for both microphones, their LEDs turn off, and
Konftel 800 displays the following message:
Upgrade in progress
Smart Mic 1: Done
Smart Mic 2: Done
In 10 seconds, the pop-up dialog window hides, and the phone enters Idle mode.
If the firmware upgrade for any of the expansion microphones fails, the
microphone LEDs turn off, and the phone displays the message stating the
Failed status of the corresponding Smart Mic.
Terminating expansion microphone upgrade
About this task
Use this procedure to terminate the expansion microphone upgrade.
You can do it in the following cases:
• The phone has one Smart Mic 1 connected; or
• The phone has both Smart Mic 1 and Smart Mic 2 connected simultaneously.
Before you begin
Connect Smart Mic 1 and Smart Mic 2 to the phone and start the upgrade process
for both expansion microphones.
55