bizhub 4700P/bizhub 4000P Service Manual
- 155 -
5. Reformat the flash device using the Flash format setting in the Utilities menu.
5.3.10 Printer Setup
Defaults
Warning—Potential Damage: Modification of the printer setting Defaults causes the NVRAM space to
be restored to the printer factory settings.
This setting is used by the printer to determine whether US or non-US factory default values should be
used. The following printer settings have different US and non-US values:
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do
not have hardware size sensing capabilities)
Default Envelope Size (envelope feeding sources
which do not have hardware size sensing capability)
Universal Units of Measure
To change this setting:
1. From the Diagnostics menu, navigate to:
Printer Setup >Defaults
2. Choose U.S. or Non-U.S.
3. Do one of the following:
- Depending on the printer model, press [OK] to save any changes.
- Press to return to the Printer setup menu.
Printed Page Count
The value of this setting gauges the amount of usage on the printer. The value of the Printed Page
Count setting will equal the values of the Picked Sides meter. After all print tests have been completed,
the value will reset to zero.
Note: The value of the setting cannot be changed manually.
Permanent Page Count
The value of this setting indicates the total amount of pages that have been printed. After all print tests
have been completed, the value will reset to zero.
To Next Page
Loading...
Need help?
General
